WSN Wiki

User Tools

Site Tools

You are here: Wireless Sensor Networks » proiecte » Using Sparrow v3 and Devicehub for indoor and outdoor monitoring
proiecte:sparrowv3-devicehub

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
proiecte:sparrowv3-devicehub [2015/10/06 10:34]
dan.tudose [Using Zigduino support in Arduino IDE] 		proiecte:sparrowv3-devicehub [2015/10/08 01:01] (current)
alex.marin [SHT21 library]
Line 18: Line 18:
  
 <imgcaption sparrowv3 | Sparrow v3.2 Wireless Sensor Node>{{ :sparrowv3.png?800 | }}</imgcaption> <imgcaption sparrowv3 | Sparrow v3.2 Wireless Sensor Node>{{ :sparrowv3.png?800 | }}</imgcaption>
-==== Using Zigduino support in Arduino IDE ====+==== Adding the Sparrow Board to the Arduino IDE ====
  
   - Download [[https://www.arduino.cc/en/Main/Software|Arduino]]   - Download [[https://www.arduino.cc/en/Main/Software|Arduino]]
Line 47: Line 47:
 2. In //Tools->Programmer// choose //USBasp// 2. In //Tools->Programmer// choose //USBasp//
  
-3. In //Tools->Board// select //Zigduino_r1//+3. In //Tools->Board// select //Sparrow//
  
 4. From //Tools->Serial Port// choose the COM port to which the node was connected 4. From //Tools->Serial Port// choose the COM port to which the node was connected
Line 84: Line 84:
 ===== SHT21 library ===== ===== SHT21 library =====
  
-There is one more thing that we must take care of before we can start playing with our WSN monitoring project. We'll need a library for reading values from SHT21, our relative humidity and temperature sensor, connected to the micro controller through an I2C interface. You'll need to use the attached files (TODO insert link towards .h and .cpp) in the following way:+There is one more thing that we must take care of before we can start playing with our WSN monitoring project. We'll need a library for reading values from SHT21, our relative humidity and temperature sensor, connected to the micro controller through an I2C interface. You'll need to use the files stored in this {{:proiecte:sht21.zip| archive}} in the following way:
  
 1. In folder //Arduino\libraries// create a new folder, named //sht21// 1. In folder //Arduino\libraries// create a new folder, named //sht21//
  
-2. Copy the attached files in it+2. Copy the files from the attached archive in it
  
 After this it will be possible to import sht21.h header into a project, as you'll see below. After this it will be possible to import sht21.h header into a project, as you'll see below.
proiecte/sparrowv3-devicehub.1444116859.txt.gz · Last modified: 2015/10/06 10:34 by dan.tudose

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
CC Attribution-Noncommercial 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki